De definitieve gids voor How to extend the life of your garage door

Next, you’ll need to lubricate the rollers, which are connected along the track ofwel the door next to the hinges. Using the thinner straw attachment for the grease will make it possible to lubricate the small ball bearings located within these rollers.

This product kan zijn applied by hand, so it’s a bit messier than aerosol sprays. However, that means it’s easier to evenly spread around. White lithium grease is made of soap and oil, so it’s non-corrosive and adheres well to metal.

Lubrication is important for a lot ofwel reasons. It will protect the door from premature wear and tear, help it move more smoothly, reduce the amount of noise and squeaking when it opens and closes, and give you years (and perhaps eventjes decades) added to your service life.

When performing these maintenance tasks, you may identify other potential issues to address that could be contributing to the excess noise that your garage door is making.

If they’re too loose, tighten them up by turning both bars clockwise, and if they’re too tight, loosen them by turning them counterclockwise. It is important to note that the springs must be equal in tension to keep your door balanced.

Daniel Walter Daniel Walter kan zijn a garage door deskundige with 15+ years hands-on experience and a degree in mechanical engineering. He's on a mission to empower homeowners with all the knowledge they need to tackle any garage-related issue with ease.

The labor required to fix a garage door depends on both the problems you’re facing, and the level of skill required to correct them. Some issues, such as loose screws or missing parts, can be fixed without substantial expertise or deep knowledge ofwel garage door mechanics. However, more serious problems may require professional support to ensure safety and accuracy.

If you can't close your garage door using either the remote or the wall-mounted switch or if the door goes partway down and then backs up, it could be a sensor issue. Try these solutions:

Remember, two springs in a system should preferably be adjusted simultaneously to maintain equal tension, providing balanced operation. Involving a second person in the process isn’t only helpful but safer.

Finally, make suitable adjustments; keep in mind that while tightening adds tension, loosening decreases it. Don’t be afraid to revisit this click to find out more process if your door doesn’t achieve optimal balance in the first go. Proceed carefully and methodically to ensure a proper adjustment.

Another reason could be that some parts are worn out or broken and need to be tightened or replaced. 

If the garage door doesn't close read all the way, turn the down limit screw counterclockwise. One full turn of the screw averages twee to 3 inches ofwel extra distance the door will travel as it closes. Turn the down screw clockwise if the door opens after it closes all the way. Do one full screw turn first and then test the door. Turn the screw again if needed. For a door that doesn't go up all the way, adjust the up limit setting.

From a ladder, open the rear flap or remove the light cover on your garage door opener. You’ll see two plastic adjustment screws labeled “up” and “down.” Using a flat screwdriver, twist the “down” screw in quarter-turn increments, checking how your garage door operates between adjustments.

You can use a wood brightening treatment to restore the wood’s real colour, but make sure to leave it dry for at least 24 hours.